Simulation and Realization of the NC Milling   Machining Process

冯裕强; 雷保珍

您当前的位置：

首页 >

文章列表页 >

Simulation and Realization of the NC Milling Machining Process

更新时间：2026-09-14

- Simulation and Realization of the NC Milling Machining Process
- NC铣削加工过程的仿真及其实现
- Issue 2, (1999)
- 作者机构：
  
  华北工学院机械工程系,山西,太原,030051
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：1999
- 稿件说明：
移动端阅览
冯裕强, 雷保珍. Simulation and Realization of the NC Milling Machining Process[J]. 1999, (2).
DOI：

冯裕强, 雷保珍. Simulation and Realization of the NC Milling Machining Process[J]. 1999, (2). DOI：

摘要

目的研究ＮＣ（ＮｕｍｅｒｉｃａｌＣｏｎｔｒｏｌ）铣削加工过程的动态仿真及其实现方法．方法基于光线投射的原理，采用将刀具与工件离散的方法，实现了ＮＣ铣削加工过程的动态仿真．结果该方法不仅能检测出加工中可能出现的干涉与碰撞，同时也能验证刀位轨迹对理想曲面的逼近误差．结论该方法成功地实现了ＮＣ铣削加工过程的几何仿真，对于工艺的仿真有待于进一步研究．

Abstract

Aim To research the method of dynamic simulation about the process of NC milling machining. Methods Based on the theory of ray casting and adopting the dispersion of tools and works

a method is developed which realizes the NC milling dynamic simulation. Results It can detect the interference and collision and also can testify the deviation of the approximated tool path from the ideal surface. Conclusion The NC milling dynamic simulation in geometry has been realized. The simulation on processing still need to be researched further.

关键词

Keywords

references

Views

100

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Optimal Design of Annular Booster Pellet

Working State Analysis of Hydraulic Excavator Based on CAE Technology

Design and Analysis of a Hydraulic System in Active Anti-Roll Device

Method of Attitude Measurement with Magnetometer and Gyroscope

Solution of Dynamic Equation in Thin-Walled Close Section Beam under Impact

Related Author

孙彬峰

胡立双

胡双启

解朝变

董超

曹亚巍

张晓辉

吕彩霞

Related Institution

中北大学化工与环境学院

天津一汽夏利汽车股份有限公司产品开发中心

中国国机重工集团有限公司

山东小鸭集团有限责任公司

中北大学机电工程学院

⁰