Failure Mechanical Analysis of Crystal Oscillator under High g Acceleration
|更新时间:2026-09-14
|
Failure Mechanical Analysis of Crystal Oscillator under High g Acceleration
高g值加速度作用下晶振的失效机理分析
Vol. 31, Issue 4, Pages: 424-428(2010)
作者机构:
中北大学理学院
作者简介:
基金信息:
DOI:
CLC:
Published:2010
稿件说明:
移动端阅览
徐鹏. Failure Mechanical Analysis of Crystal Oscillator under High g Acceleration[J]. 2010, 31(4): 424-428.
DOI:
徐鹏. Failure Mechanical Analysis of Crystal Oscillator under High g Acceleration[J]. 2010, 31(4): 424-428.DOI:
Failure Mechanical Analysis of Crystal Oscillator under High g Acceleration
摘要
利用Hopkinson杆对弹载存储测试电路模块常用的两种晶振:EXO3
KSS晶振
在未用环氧树脂胶灌封和灌封状态下进行了不同冲击方向(沿平行和垂直方向)的抗高g值冲击性能研究
并对它们的失效机理进行了分析.结果表明:因为晶振内部有微梁
当晶振在高g值加速度冲击下时
微梁可能发生断裂
这将导致晶振的失效.另外
晶振抗冲击能力与冲击加速度方向有关
与冲击方向平行时晶振的抗冲击性能要明显高于与冲击方向垂直的情况;对同一个冲击方向而言
经过环氧树脂灌封的晶振抗冲击能力并没有明显高于未灌封的晶振
这可能是由于电路板上焊点、导线断开造成的.
Abstract
The Hopkinson bar was employed to the anti-high g shock capability of two kinds of crystal oscillator often used in on-board memory test circuit: EXO3 and KSS which was no-potted or potted with epoxy resin and potted along vertical and parallel direction to the shock
then its failure mechanism was analyzed.It shows that because the micro-beam exists in the crystal oscillator
which will rupture and result in failure to the crystal oscillator acted by high g shock acceleration.Moreover
the anti-high g shock capability of crystal oscillator is related to the direction of shock acceleration
and the capability in parallel direction is distinctly better than that in vertical direction;for the same shock direction
the anti-high g shock capability of the potted crystal oscillators aren′t distinctly better than in the nopotted
which is likely to be caused with the break of welded points
leads on the circuit plate.
关键词
Keywords
references
Zhang W D,Chen L J,Xiong Jijun.Ultra-high g deceleration-time measurement for the penetration into steel target[J].International Journal of Impact Engineering,2007,34(3):436-447.
Booker P M,Cargile J D.Investigation on the response of segmented concrete targets to projectile[J].InternationalJournal of Impact Engineering,2009,36(7):926-939.
Forrestal M J,Frew D J,Hickerson J P,et al.Penetration of concrete targets with deceleration time measurements[J].International Journal of Impact Engineering,2003,28(3):479-497.
Rohwer T A.Miniature,singile channel,memory-based,high g acceleration recorder[R].SandianationalLaboratories,SAN099-1392C,1999.
徐鹏,祖静,范锦彪.高速动能弹侵彻硬目标加速度测试技术研究[J].振动与冲击,2007,26(11):118-122.Xu Peng,Zu Jing,Fan Jinbiao.Study on acceleration test technique of high velocity kinetic energy projectilepenetrating into hard target[J].Journal of Vibration and Shock,2007,26(11):118-122.(in Chinese)
郇勇.用Hopkinson杆冲击加载研究高量程微加速度计芯片的抗过载能力[J].传感技术学报,2003(2):128-131.Huan Yong.Study of shock-resistibility of high-g microaccelerometer chip through impact using Hopkinson bar[J].Chinese Journal of Sensors and Actuators,2003(2):128-131.(in Chinese)
徐鹏.CPLD芯片抗高g值冲击性能分析[J].振动与冲击,2007,26(1):148-150.Xu Peng.Analysis of anti-multi-g-shock capability of a CPLD chip[J].Journal of Vibration and Shock,2007,26(1):148-150.(in Chinese)
董健.冲击硅微机械加速度传感器的封装与封装性能分析[J].传感技术学报,2008,21(6):959-963.Dong Jian.Package of silicon micromachined shock accelerometer and package performance analysis[J].ChineseJournal of Sensors and Actuators,2008,21(6):959-963.(in Chinese)
王礼立.应力波基础[M].第2版.北京:国防工业出版社,2005.
李乐,祖静,徐鹏.晶振芯片在高g值冲击下的失效机理分析[J].仪器仪表学报,2006,27(增刊),2589-2590.Li Le,Zu Jing,Xu Peng.Failure mechanism of crystal oscillator under high-g shock[J].Chinese Journal ofScientific Instrument,2006,27(Supplement):2589-2590.(in Chinese)
李乐,祖静,徐鹏.EXO3晶振与KSS晶振在高过载下的失效特性分析[J].中国测试技术,2007,33(3):88-90.Li Le,Zu Jing,Xu Peng.Failure mechanism of crystal oscillator EXO3 and KSS under high shock[J].ChinaMeasurement Technology,2007,33(3):88-90.(in Chinese)