提高研磨介质与PET基材粘接强度的方法研究

武志芳; 高子亮; 沈健

您当前的位置：

首页 >

文章列表页 >

提高研磨介质与PET基材粘接强度的方法研究

更新时间：2026-09-14

- 提高研磨介质与PET基材粘接强度的方法研究
- 提高研磨介质与PET基材粘接强度的方法研究
- Issue 6, (2007)
- 作者机构：
  
  中国电子科技集团公司第33研究所
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2007
- 稿件说明：
移动端阅览
武志芳, 高子亮, 沈健. 提高研磨介质与PET基材粘接强度的方法研究[J]. 2007, (6).
DOI：

武志芳, 高子亮, 沈健. 提高研磨介质与PET基材粘接强度的方法研究[J]. 2007, (6). DOI：

摘要

从粘接机理及影响粘接强度的物理和化学因素两方面

分析了影响研磨介质与聚对苯二甲酸乙二醇酯(PET)基材之间粘接强度的各种原因

并在此基础上拟定了相应的试验方案

试制了相应的样品.经过粘接强度的对比测试

确定出了最佳试验方案.试验结果表明:对PET基材表面进行电晕处理

再涂敷由聚氨酯

聚乙烯系树脂(VAGH)

有机硅偶联剂(WD-60)

SiO2配制而成的厚度约为1.5μm的底胶

并在此基础上涂敷研磨介质层

此时研磨介质层与PET基材的粘接强度有了明显的提高.

Abstract

Diversified reasons influencing adhesive strength between abrasive medium and PET base materials are analyzed in terms of adhesive mechanism and physical and chemical factors.The corresponding experiment project was worked out and the sample product was made.Through the comparison test of adhesive strength of samples

an optimal experiment project was confirmed.The experimental results show that

by corona treatment on the surface of PET base material

coating bottom pastern of about 1.5 μm composed of polyurethane

VAGH

organosilicon coupling agent

and SiO2

and then coating abrasive medium

the adhesive strength between abrasive medium and PET base material is obviously enhanced.

关键词

Keywords

references

Views

214

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

A Meta⁃Learning and VAE⁃GAN Based META⁃VAEGAN⁃DNN Method for Network Intrusion Detection

Adaptive Shock Wave Overpressure Sensing for Dynamic Explosion Testing

Hopkinson Bar Pulse Width Extension Test Method Based on Polyurethane Wave Shaper

Research Progress on Single⁃Photon Detection for Quantum Information About Mechanisms，Devices and Circuit Design

Configuration Design and Research of a Hybrid Quadruped Perilla Sowing Robot

Related Author

No data

Related Institution

No data

⁰