Based on sapphire optical fiber blackbody cavity temperature sensor
an extrapolation measuring method for transient high-temperature was presented.The mathematical model was established and solved by separation of variables.On this basis
by CO2 laser simulating the transient high-temperature heat source
the sensors and high-speed infrared thermometer were simultaneously used to measure the temperature change inside and outside the black body cavity film.The experimental results show that the extrapolation temperatures obtained by separation of variables are consistent with the temperatures detected by infrared thermometer in the change trendency and the peak value aspects
which proves the correctness of the extrapolation model.At the same time
Ansys software is used to simulate the transient heat transfer process of the blackbody cavity heated
which proves the correctness of extrapolation model in the opposite direction.
Nicholas J V,White D R.Traceable Temperatures:An Introduction to Temperature Measurement and Calibration[M].2nd ed.John Wiley&Sons,2001:21-24.
Waldemar Minkina.Theoretical and experimental identification of the temperature sensor unit step response non-lin-earity during air temperature measurement[J].Sensors and Actuators,1999,78:81-87.
Lahoucine C O,Khellaf A.Periodic method:correction for thermocouple and simultaneous estimation of thermalconductivity and thermal diffusivity[J].Review of Scientific Instruments,2004,75(7):132-135.
Hodgson P D,Kong L X,Davies C HJ.Prediction of hot strength in steels with an integrated phenomenological andartificial neural network model[J].J.Mater.Process.Technol.,1999,87:132-139.
Hodgson P D,Collinson D C,Davies C HJ,et al.The application of phenomenological,empirical and ANN modelsto the predication of hot strength in steels[C].IPMM’97,Brisbane,Australia,1997:961-967.
Kong L X,Hodgson P D,Collison D C.Modelling the effect of carbon content on hot strength of steels using a mod-ified artificial neural network[C].ISIJ Int.,1998(38):1121-1129.
Kong L X,Hodgson P D,Collison D C.Extrapolative prediction of the hot strength of austenitic steels with a com-bined constitutive and ANN model[J].Journal of Materials Processing Technology,2000,102:84-89.
Mano J F,Cahon J P.A simple method for calibrating the temperature in dynamic mechanical analysers and thermalmechanical analysers[J].Polymer Testing,2004,23:423-430.