
浏览全部资源
扫码关注微信
1. 上海大学环境与化学工程学院
2. 上海为泰环保科技事务所
3. 上海市环境工程设计科学研究院
纸质出版:2009
移动端阅览
陈丹, 于义忠, 朱化军, 等. 电镀污泥水热合成掺杂的四氧化三铁[J]. 中北大学学报(自然科学版), 2009,(3).
陈丹, 于义忠, 朱化军, et al. 电镀污泥水热合成掺杂的四氧化三铁[J]. 2009, (3).
以电镀污泥为掺杂源水热合成掺杂的F e3O4
实现电镀污泥的资源化与自净化.选择尿素作为F e2+
F e3+沉淀剂
通过分析电镀污泥掺杂量、反应时间及反应温度对水热合成F e3O4的影响
确定最佳试验条件为:铁源与电镀污泥质量比4∶1
反应时间4 h
反应温度160℃.研究结果同时表明
在掺杂F e3O4中
铜的浸出毒性较大
镍次之
但锌、铁、铬的毒性浸出在pH值为3~10范围内低于美国固体废物毒性浸出(TCLP)方法的标准.因此
含铜量高的电镀污泥不适于用作掺杂源
应优先考虑含锌、铬污泥.水热合成的掺杂电镀污泥的F e3O4
其粉体颜色呈黑色
磁性强
分散性好
粒度细小
分布较为均匀.
Doped Fe3O4 was synthesized from electroplating sludge by hydrothermal reaction which used urea as the precipitator of FeCl2 and FeCl3.Through analyzing the effect of the doping amount
reaction time
and the reaction temperature on the synthetic Fe3O4
it indicates that when the mass ratio of iron source to electroplating sludge is 4∶1
the reaction time is 4 h and the temperature is 160 ℃
the best experimental result can be explored.And the research shows that: in the acidic leaching condition
Cu in the doped Fe3O4 has the largest leaching concentration
Ni takes the second place;Zn
Fe and Cr have a good stability
and the concentration is lower than the regulatory limit of Toxic Characteristic Leaching Procedure(TCLP) in pH range of 3~10.Therefore
the electroplating sludge enriching Cu is not suitable for doped source
and that enriching Zn and Cr is a good choice.The black doped Fe3O4 has a better magnetism
and is weakly agglomerated and equably distributed.
0
浏览量
323
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621